Fermentation straw feed four methods
Using a goldfish straw fermentation agent to produce feed is not only simple but also cost-effective. After treatment with the Golden Baby straw fermentor, the nutritional value of the straw increases, and its texture becomes softer with a slightly sour aroma. While this type of feed has high palatability and is usually well-liked by livestock and poultry, improper feeding methods can lead to some animals refusing to eat or eating less due to unfamiliarity, which may negatively affect overall feeding performance. To avoid this issue, it's important to be patient and gradually introduce the fermented feed into their diet. Here are several effective feeding strategies you can try:
1. **Hunger Guidance Method** – Feed a small amount of fermented feed before the livestock or poultry are hungry, followed by regular feed. This helps them slowly get used to the taste of the fermented feed.
2. **Mixing Method** – Start by mixing a small portion of fermented feed with concentrate feed. Gradually increase the ratio until it reaches 50-80%.
3. **Odor Induction Method** – Place the fermented feed at the bottom of the feeding trough, and cover it with regular forage grass. This allows animals to gradually get accustomed to the smell or taste of the fermented feed.
4. **Gradual Introduction Method** – Mix the fermented straw feed with other commonly used forages and feed them gradually. Start with small amounts of fermented feed and increase the quantity over time.
By following these steps, you can ensure a smooth transition and maximize the benefits of using fermented feed. It’s all about patience and consistency. With time, your livestock will adapt and enjoy the improved quality of their diet.
Roundness tester is a length measuring tool for measuring roundness using the rotary axis method. The roundness meter is a measuring tool for measuring the roundness error of the workpiece using the rotary axis method. Roundness tester is divided into two types: sensor rotary type and workbench rotary type. During measurement, the measured part is installed concentrically with the precision shaft system, and the precision shaft is attached with an inductive length sensor or a workbench for precise circular motion. It is composed of sensor, amplifier, filter and output device of the instrument. If the instrument is equipped with a computer, the computer is also included in the system.Roundness Tester
The principle of the roundness meter is the same as that of the coordinate measuring machine. In fact, its working principle is very simple. The coordinate measuring machine is a point acquisition tool. Its principle is to collect points first, and then form a line from points, and then form a three-dimensional model from lines. CMM is a kind of measuring equipment that has a guiding mechanism, a length measuring element, a digital display device in three mutually perpendicular directions, and a worktable that can place the workpiece (not necessarily large or huge). The measuring head can be moved to the measured point easily by manual or motorized means, and the coordinate value of the measured point is displayed by the reading device and the digital display device. Obviously, this is the simplest and most primitive measuring machine. With this measuring machine, the coordinate value of any point in the measured volume can be displayed through the reading device and digital display device.
Roundness Measuring Instruments ,Roundness Measuring Machine,Instrument Used To Measure Roundness,Roundness Tester,Gear profile measuring instrument
Zhejiang dexun instrument technology co., ltd , https://www.dexunmeasuring.com