The tractor oil leakage includes a variety of situations. To solve the tractor oil leakage, we should analyze the specific problems. Here's a look at the three scenarios of tractor oil leakage and specific solutions:
One, rotary shaft oil leakage
The rotary shaft includes a starter shift lever shaft and a clutch handle shaft and an engine relief shaft. If the shaft and the hole wear together, the gear lever shaft and the clutch handle shaft of the starter can be wheeled out of the sealing ring groove on the lathe. At this time, only the corresponding size of the sealing rubber ring can be installed. If the aging of the apron due to the decompression shaft fails, the new apron should be replaced.
Second, screw plug oil plugging oil
Plug plug oil plugging oil includes cone plugging, plugging, and process plugging. If the plug screw is damaged or fails, it should be replaced with a new one. If the plug screw is damaged, the screw bore size can be increased and the new plug can be installed. Oil plug. If it is worn due to taper, it can be changed to flat plug after tapping, and then it can be used again.
Third, the plane seam leakage
Plane seams include two planes sealed with paper pads, asbestos pads, and cork. If the contact surface is uneven or there are grooves or burrs on the contact surface, according to the degree of unevenness of the contact surface, the use of assorted files, fine sandpaper, or stone grinding, large machine can be used to machine flat. In addition, the assembled gaskets must be qualified and cleaned at the same time. If the bolt is loose, tighten the fixing bolts.