Many customers may encounter some faults in the process of using the dryer. There is no way to repair them in time. Some glitch customers can repair them by themselves. Some of the faults below are some situations that you can repair by yourself.
1. The moisture content of the material after drying is greater than the specified value. The elimination method is to control the output of the dryer and increase or decrease the supply of heat.
2. The operation of the cylinder is oscillating during operation. The reason is that the side of the concave joint of the rolling ring is not clamped. The elimination method is to keep the rolling ring and the concave joint evenly and properly clamped by the pad. .
3, the large gear meshing with the pinion is damaged <br> <br> gap
is because a. Tug wear B. C gear wheel wear. Pinion gear wear. The elimination method is to turn or replace according to the wear condition, or it can be installed on the reverse side or in pairs.
4, the barrel
is because vibration <br> <br> a tug means connected with the base is broken, the correction method is to eliminate the fastening parts, it is in the correct position.;
b. The side of the raceway is worn out. The elimination method is to turn or replace the raceway according to the degree of wear.
The maintenance and maintenance work of the high-humidity material drying equipment is very important. It is not only related to the length of the equipment life, but also has a great influence on the output quality of the dried material. What aspects of the maintenance process are we can think of to improve and improve drying efficiency?
Take the slime dryer as an example: when installing the screen, the burr side of the screen hole should face inward, the smooth side should be facing outward, and the screen and the screen frame should be tightly attached. When the screen sieve is installed, the splicing The inner layer of the cornice should follow the direction of rotation to prevent the material from getting stuck at the joint. In the production process, the screen is adjusted according to the production needs.
*, increase the vibration amplitude;
Second, the screen and the cuttings are washed with sprayed water to reduce the stickiness of the cuttings, but this method is only suitable for occasions where water is allowed to be added;
Third, adjusting the angle of the screen at the end of the sand outlet is downward, which is good for the cuttings to be discharged by gravity, but may cause running;
Fourth, replace the mesh number of the screen or adjust the flow rate of the single screen to ensure that the flow stop point of the drilling fluid is close to the screen outlet, so that the drill cuttings can be smoothly discharged under the lubrication of the drilling fluid.
Through the above adjustments, the operation process of the dryer can be smoother, and the quality of finished products can be improved. The above is simply starting from the adjustment of the screen, and there are more maintenance details that need everyone to pay attention to, interested Friends can communicate with the staff of Shanghai Han. Shanghai Island Han Industrial Co., Ltd. specializes in the research and development of scientific instruments and environmental equipment. It operates all kinds of drying ovens, incubators, test chambers, oscillators, and agents.
Cooling Patch(Gel series)
Surgimed Medical Supplies Co.,Ltd , https://www.surgimedcn.com