What happened to the leaking oil and oil quick joint?

Water leakage is a dysentery in the water purifier industry, and almost 80% of manufacturers encounter this situation when using water purification equipment. Oil spills are also a major problem for the petrochemical industry. Thus, a quick connector is produced. The quick connector is equivalent to a switch that enables the communication and disconnection of the medium.

However, there are still many merchants who report that the quick connector used is still leaking or leaking. Please check several aspects: whether the compatibility of the pipe is strong enough; whether the pawl of the quick connector grasps the pipe; whether the built-in seal is Tightly squeeze the pipe mouth; whether its temperature resistance meets the current required ambient temperature; whether the pressure resistance of the quick joint meets the design standards. After reviewing in many ways, start again and rectify. In most cases, it takes a long time to use, resulting in a loose connection between the quick connector and the nozzle, or it is often caused by looseness. But as long as the usual attention to maintenance, you can still reduce this loss.

The quick connector has the advantages of saving time and labor, saving fuel, environmental protection and convenient transportation. It is the advantage of simple operation, time saving and manpower when disconnecting and connecting the oil circuit through the quick joint, which leads to its continuous operation in operation, but it can not be immediately maintained, and it is easy to cause water leakage after a long time. Oil phenomenon. At the same time, it should be noted that whether the design of the quick connector before the installation meets the excuse requirements of the pipeline, it must be cautious, so as to reduce the cost loss of the enterprise.