What are the reasons for the low washing rate of empty bottle washers?

The reason why the empty bottle washing machine has a low washing rate

1. The temperature and concentration of lye are not suitable

The temperature and concentration of the lye are the main factors affecting the quality of the washing bottle. If the temperature and concentration of the lye are too low, the bottle will not be cleaned. When the concentration and temperature are too high, the standard will be shredded, and the paper wall and paper fiber will be clogged. The condition of the nozzle. This requires the combination of water quality, label paper quality, and the selection of suitable bottle washing additives. Many domestic single-end bottle washers install the addition position of alkali and detergent additives on the side of the filtration storage tank of the alkali-slot removal net, so that the alkali and the detergent additive are immediately pumped out by the water pump, which not only produces foam, but also a part of alkali and The detergent additive will be taken out of the labeling net together with the waste paper to cause waste.

2. Empty bottle washer has a short soaking time

For bottles with a long turnover cycle, the soaking time should be appropriately increased to solve the problem of plaque washing.

3. Insufficient pressure on the spray

Alkali 1 pumped out two points in the day, one way to remove the large spray, and the other way to be heated by the heater, and then sprayed into the bottle bottom bottle and the alkali 1 tank liquid circulation. When the capacity of the alkali 1 water tank is insufficient, since the alkali 1 has a large flow rate of the spray liquid and is transported at a relatively close distance, the internal spray pressure of the alkali 1 is insufficient.

4. The empty bottle washing machine is deformed by the bottle holder, which causes the nozzle and the bottle mouth to be misaligned, and the bottle washing effect is poor.